Description

Another Dazzle Ride problem solver; this clever strip can be cut at any of its marked cut points (every 4 cm) and then adjusted to still flow symmetrically from the new “center”; making it a very elegantly sizable symmetrical center flow DRL strip.  No more trying to find that just right size, and then complicated programming, this is truly one size fits all with super easy setup.

We used to only be able to do this in some custom sizes on higher end builds with the very complex (and costly) controllers that can be programmed with how many pixels are in each strip, where to start, direction of flow etc.  With these, you cut to your preferred size and then you just use the two buttons on the controller to set where the new center is, brightness level, and your running light and turn signal preference.  That’s it.

The strips are the super bright variety but can be set to a lower brightness level if preferred.

• Slick startup scan function
• Two brightness modes
• Two colors (white/yellow)
• Set and forget static white or rotation of dynamic white patterns for the running light function (at either brightness mode)
• Turn signal function (up to half of strip can dynamically signal in dynamic moving bright yellow for left and right turn signals)
• IP68 water-proof; strips and strip wires can function completely submerged in water*
• 12v
• 1.2m (48″) length (2.4m (95″) length available via special order)
• Easy connection (power & ground plus optional left turn & right turn if desired)

*If the strip needs to be cut to size, the end cap on the cut end must be re-attached with silicone adhesive to restore water-proof integrity.