Each Dazzle Ride LED whip set comes with two sample whip flags and the hardware to attach the flags to the whips columns. Keep in mind you can also custom order flags for your LED whips with any design of your choosing or creation here!
To install flags, simply spread the provided metal brackets (with rubber coverings) open and push into place around a whip at the top positioning each attachment bracket about where you want the grommets of the flag to be located after installation. Use one of the small bolts to pass through one side of the bracket, then insert the bolt through one of the small figure 8 attachment pieces and finally have the bolt exit the other side of the bracket. Secure with a nut.
The other side of the figure 8 attachment wire is threaded onto the snap ring. And each of the snap rings attaches through a grommet hole on the flag.
See pic below:
